Special Offers

Note: This item is sold at a discount because of blemished pins (due to long storage).Maximum Recurrent Reak Reverse Voltage: 600VMaximum RMS Bridge Input Voltage: 420VrmsMaximum Average Rectified Current: 4ASurge Current (1/2 cycle): 200AMaximum Forward Voltage per element: 1.1VIt Rating for fusing..

Dual Drive Shaft Gear motor. Nidec Servo. Made in JapanNominal Voltage: 24VDCNo Load Current: 250mA TypicalNo Load Speed: 630 rpm Gear output drive shaftGear Ratio: 5.8:1Power: 19W approx.Output Stall Torque: 1.7 Nm approx.Drive Shaft Geared Output: d6x73mmDrive Shaft Motor Output: d5x31mmMotor+ Bac..

e-Gizmo LSF02 Multi-Voltage level converter breakoutboard it can translate up to 4 signals:Allows Bidirectional voltage level translation between 0.8 V <--> 1.8/2.5/3.3/5V 1.2 V <--> 1.8/2.5/3.3/5V 1.8 V <--> 2.5/3.3/5V 2.5 ..

A complete microstepping motor driver with built-in translator for easy operation. It is based on 3 different variants of A3983,A3984 and A4984 IC. Designed to operate bipolar stepper motors in full-half, quarter and eight-step modes.e-Gizmo Microstep Driver is an ideal fit for applications where a ..

Solderless Breadboard 830 points..

e-Gizmo Load Cell Display Unit offers an easy and affordable weighing scale function for your projects. By just adding an appropriate load cell, it is possible to build a standalone unit. It has a user presettable comparator function (High-Low) that you can use for simple weight detection and screen..

Cigarette Lighter Plug to DC Barrel Plug coiled cord.Replaceable Fuse: 6g2A 2A Fast Blow (3A6 size)Cord Length: 1.8M approxMini DC Barrel Plug: d3.5 x 1.35mmBarrel Plug Polarity: Tip (+), Sleeve (-)..

EZ HMI Display Terminal is an easy to use display and input device for your MCU based applications. It communicates via a logic level UART channel requiring only two I/O pins, RX and TX, to communicate with any UART equipped MCU. It has several built-in functions that allow you to easily implement a..

Add ESP-11 wifi connectivity to your gizDuino/Arduino without soldering. Just plug it in, and you are ready to go. All support components needed to interface the ESP-11 with the Arduino are already on-board.Specifications :Power Input3.3V Operating voltage (ESP8266) +5V DC (Internal supply MCU) ..

DC GEARED MOTOR 6V (Straight Type)..