All Products
The MPR121QR2 is a capacitive touch sensor controller that makes it very easy to integrate capacitive touch sensing into your project. It communicates via I2C, and works by measuring the capacitance of twelve electrode points. When an object comes close to the electrode connector, the measured capac..
₱180.00
-44%
Mini
NodeMCU 4M bytes Wifi Internet of
THINGS devboard based ESP8266Features :11 digit i/o pins, all pins have interrupt/pwm/I2C/onece-wire supported (except D0).1 Analog input (3.2V Max input)Micro USB Programming PortCompatible with gizDuino, Arduino and N..
₱159.00 ₱286.00
FREE 8GB Micro SD card!!Lightweight Mini DVR Camera with card reader, accessories, and FREE 8GB uSD Flash.-720p/1080p FULL HD recordings- Built-in LiPo battery can record up to 60-minutes of video with one full charge.- USB 2.0 & Video Out Port- Camera weigh just 11 grams.Secondary Drone Camera,..
₱1,700.00
Pre-order
Mini Bot Chassis DisassembledSpecifications :Power Input (Motor)
6VDCWeight:
0.5KGDimensions:Length:
115 mm
Width:
132 mm
Height:
97 mm with Spoiler,w/o 60 mmDownloads :Assembly Manual
Download..
₱799.00
Applicable to any water measuring projects such as water tank monitoring, aquarium level, or even refilling containers that needs measurement.Specifications :Wire Length
395mmMax Switching Current
0.5AWidth x Length
24x66mmMaximum Load
50WMaximum Load Current
1A
..
₱109.00
A light sensor with easy to use digital and adjustable sense of the light intensity hitting the sensor. The digital output is a 1 bit digital output that switches state when the light intensity reaches a certain threshold. This threshold is a user presettable through the use of a trimmer resistor. S..
₱31.00
-21%
L298N IC as the main driver chip with a strong driving capability, lowheat, anti-interference ability.Specifications :Power Input
12VDCLogic Voltage
5V,0A-0.36AMaster Chip
L298NOperating Mode
H-Bridge Drive (Dual)Drive Current
2A (Max) Single BridgeMaximum Po..
₱115.00 ₱146.00
This passive buzzer module has a built-in driver, hence you can connect its input directly to a has controller. Note that this is not a stand alone buzzer, it requires a driving signal form a host controller. This buzzer is at its loudest when driven with a 2Khz-5KHz square wave. Compatible with all..
₱27.00
Pre-order
Note: This product may no longer be available. Click here for the suggested replacement.The Hall Magnetic Sensor has a single signal output pin. It can be used for motor speed and position detection.Specifications :Power Input
5VDCSensor
3114 Hall Effect SensorOn-Board IC
LM39..
₱53.00
G-Tank DisassembledPrototyping Chassis with heavy duty geared motors.
Specifications :Power Input
7-9VDCWeight
1KgDimensions:Length:
245 mm
Width:
210 mm
Height:
104 mm with Spoiler, w/o 62 mm, 22 mm space from bottom chasis to the ground.Dow..
₱2,749.00
EGRA Disassembled, makes you build your own robotic arm.Demo Video :Specifications :Power Input (Servo)
5VDCModel Servo Motors:
4PCS - SG-90 (160 degrees)Weight:
0.207 KG (with Buck Converter,wires,suction cup)Load can carry:
less than 1KGDimensions:..
₱1,350.00