General Purpose Break-out Adapter Board for ESP07 , ESP08, & ESP12 Wifi Modules.This board provides a convenient way to connect your ESP module to a breadboard or other circuit modules.-With pre-soldered resistors.-Solder pads for the optional voltage regulator.Weight: 4gNote: PCB Board and pin ..
e-Gizmo Universal Wireless Controller is a generic PS2 controller fitted with custom programmed 433MHz Transceiver module. When paired with e-Gizmo UHF STD or UHF EX transceiver module, a wireless UART connection with a host controller (e.g. gizDuino/Arduino) can be easily implement. Building a Robo..
The most complete, most convenient, and the most stable bluetooth data transmission, remote control, PIO acquisition module. Specifications :BT Version:
Bluetooth Specification V4.0 BLESend and receive:
no bytes limit Working frequency:
2.4GHz ISM bandModu..
The new e-Gizmo SIM800 Dev board is packed with more features, yet cost much less*. e-Gizmo SIM800 GSM/GPRS Dev kit is a quad-band GSM/GPRS module designed with power saving technique so that the current consumption is as low as 0.7mA in sleep mode. In application, controlling device controls via it..
SIM800L GPRS GSM Module with Microsim Card Breakout board with UART and voice channel I/O. Popular with M2M, security, and home automation applications where remote control and monitoring is desired while you are on the go. gizDuino/Arduino compatible, supported by open source libraries.Downloads :
..
the SIM900D delivers GSM/GPRS 850/900/1800/1900MHz performance for voice, SMS, Data, and Fax in a small form factor and with low power consumption. With a tiny configuration of 33mm x 33mm x 3 mm, SIM900D can fit almost all the space requirements in your M2M applications, especially for slim and com..
e-Gizmo RFID Card Reader 2 can be used as a stand-alone RFID Card Reader, or can be connected to a host controller (e.g. gizDuino/Arduino). It can store up to 100 RFID cards assigned with a unique 7-bit address each. A host controller can detect and read the card two ways: via its 7-bit addres..
Add ESP-11 wifi connectivity to your gizDuino/Arduino without soldering. Just plug it in, and you are ready to go. All support components needed to interface the ESP-11 with the Arduino are already on-board.Specifications :Power Input3.3V Operating voltage (ESP8266) +5V DC (Internal supply MCU) ..
ESP-07 WiFI Module is one of the ESP family with 9 GPIOs pins, RST, CH_PD, ADC, VCC and GND connections. Serial Interface/ UART. Compatible in all gizDuino boards...
Class II Bluetooth module with SPP profile (Wireless serial cable replacement). 3.3V UART output. User configurable parameters using simple set of AT commands. Module available in Master/slave EGBT-045MS and lower cost slave only EGBT-046S device. * Class II Bluetooth device typica..