Wireless Kits and Modules

Add ESP-11 wifi connectivity to your gizDuino/Arduino without soldering. Just plug it in, and you are ready to go. All support components needed to interface the ESP-11 with the Arduino are already on-board.Specifications :Power Input3.3V Operating voltage (ESP8266) +5V DC (Internal supply MCU) ..

Class II Bluetooth module with SPP profile (Wireless serial cable replacement). 3.3V UART output. User configurable parameters using simple set of AT commands. Module available in Master/slave EGBT-045MS and lower cost slave only EGBT-046S device.  * Class II Bluetooth device typica..

Add wireless functionality with your projects with e Gizmo Wireless Infrared Remote Control system. Includes an 11 function infrared remote controller that correspondingly turns ON or OFF  11 remotely controlled outputs. Easily integrates with existing circuits. Features :Across the Room contro..

Receiver only version of UHF-STD Wireless UART kit.Features :1 to 15 multi channel data reciver with 400kHz.spacingAvailable in 433mHz or 315mHz frequency.Channel selection control can be passed on to the host controllerSpecifications :Frequency Range: 431.1 MHz – 437.3 MHzChannel Separation: 400kHz..

UHF-STD Data Transceiver is a transparent wireless UART tranceiver with 100mW RF output. This RF power allows a useful control range of more than 200mFeatures : 1 to 15 multi channel data transceiver with 400kHz.spacing Available in 433mHz or 315mHz frequency. Channel selection control can be pas..

The new e-Gizmo Personal Broadcaster MK II kit is a low power educational FM transmitter unit that can be used for instructional training and practice broadcast. Use with laptop running a sound mixing software and you can instantly become a radio DJ. Use with a personal MP3 player were you instantly..

The TEA5767HN is a single-chip, electronically tuned FM stereo radio for low-voltage applications with fully integrated Intermediate Frequency (IF) selectivity and demodulation. The radio is completely adjustment-free and only requires a minimum of small and low cost external components. The radio c..

UART-WiFi is an embedded module based on the UART serial, in accordance with the WiFi wireless WLAN standards, IEEE802.11 protocol stack and TCP / IP protocol stack. It enables the data conversion between the user serial and the wireless network module through the UART - WiFi module. Traditional ser..

The EGRF-433A1 transmitter and receiver pair is a low-cost solution for radio wireless control application circuits. Operating at 433MHz ISM frequencies, this low power radio system has a remote operating reach of more than 100 meters in open field (125 meters/370 ft being typical) . The control dis..