Special Offers
-14%
Pre-order
The **Breadboard Plug-in Power Supply Module** is a device that provides regulated voltage rails for project circuits on a solderless breadboard. It can be powered using an input voltage range of 6.5 Volts to 12 Volts. The module has two voltage regulators which output 3.3 Volts and 5 Volts. It also..
₱59.00 ₱69.00
-6%
Metal gear, ball bearing ServomotorWorking Torque: 2kg-cmSpeed: 0.11s per 60 degrees rotation @ 4.8VDCDead Zone: 5 usRotation angle: 180 degrees (+/-90)Voltage: 4.8-6.0V..
₱120.00 ₱127.00
-17%
5V 2 Channel Optoisolated Relay ModuleWorking Voltage: 5VRelay Contact Ampacity: 10ATrigger Level: Active LowCompatible with 3.3V to 5V logic drive (eg. gizDuino, Arduino, Raspberry Pi)..
₱75.00 ₱90.00
-56%
-56%
-11%
Pre-order
Voice Recognition ModuleSpeaker independent voice recognition- Stores up to 15 stored voice instructions- Microphone included- >90% recognition rate- UART Interface- 5V supply VoltageDownloads :Voice Recognition V2 Manual
DownloadsWiring Diagram
DownloadsArduino Sample S..
₱1,250.00 ₱1,399.00
-31%
Brand: Litech
Branded 25 pins db25 Female Connector kit with Shell.Shell kit includes cable retainer clips and holding screws...
₱68.00 ₱98.00
-70%
Brand: Xeno
3.6V 1.2Ah Lithium Battery with connectorNo RechargableMax cont current: 30mAsize: 1/2 AA/ ER15252Note: Manufacturing date 2014. Good for use until at least 2024 (10 years shelf life)..
₱75.00 ₱250.00
-10%
Pre-order
Resistive type Thin Film Force Sensor 500g- Open circuit when no force/no bending is applied along its lenght- Responds to flexing/bending, hence it can also be used as a low cost flex sensor..
₱175.00 ₱195.00
-4%
The **L293D Motor Driver Shield** is a device that can be used to control DC, stepper, and servo motors using an Arduino board. It is compatible with the Arduino UNO and MEGA boards. The shield features two L293D motor driver ICs and one eight-bit shift register chip. The L293D IC is a low-voltage o..
₱134.00 ₱140.00
-0%
Brand: e-Gizmo
ATMEGA328P Arduino Uno CompatiblegizDuino UNO-SE (Student's Edition) is 100% code compatible with Arduino Uno. It is built for the budget but with the best possible quality. To obtain to most competitive price, we used the same USB bridge CH340 universally used by China UNO compatible manufacturers...
₱199.00 ₱199.00
-11%
Pre-order
NodeMCU-32S IOT Development BoardESP32 is a single 2.4 GHz Wi-Fi and Bluetooth combo board- ESP32 WIFI Module- Powerful 32-bit processing- supports LWIP protocol, Freertos-Three modes: AP, STA, and AP+STA-Support LUA program for easy code developmentImportant Note: Module physical appearance may var..
₱330.00 ₱372.00