*Robotic Stuffs

103H78 series 2-phase Unipolar Stepping Motor* Short Drive Shaft d8 x 8.5mmManufacturer: Sanyo Denki Frame size: 60mm (NEMA 24)Drive Method: UnipolarPhases: 2Current: 2.0A per phaseWinding Resistance: 1.8R per phaseInductance: 3.6mH per phaseHolding Torque: 1.17 N*mRotor Inertia: 0.4 kg*m2Weight: 67..

VT307 Series 3-port Solenoid ValveCoil Voltage: 24VDC +/-10%Coil Power Consumption: 4.2WPort Size: 1/4Fitting: d6mm/e6Fluid: Air/Inert GasOperating Pressure: 0 to 0.7MPaMaximum Operating Frequency: 10HzNote: This item is a quality used surplus in good working condition. Affordably priced for hobby a..

Pressure to Vacuum Generator.Mfr: FestoOperating Pressure: 0.15 to 0.8MPaNominal Operating Pressure: 0.6MPaMax. Vacuum: 85%Pneumatic Connection: M5Valve Operating Voltage: 21.6 to 26.4VDC Duty Cycle: 100%Vacuum Switch: NoneInclusion: d6mm x M5 90 degrees fittingsNote: This item is a quality used sur..

Popular commercial and hobby stepper motor.Type: Unipolar, 4 phaseWorking Voltage: 5VMotor Step Angle: 64 steps per revolution (5.625 degrees per step)Number of wires: 5Wire Termination: 2.54mm Female Wafer ConnectorImportant Note:The following parameters may vary according to manufacturer. We canno..

Generic MG996 RC Servo Motor w/AccessoriesAll Metal Gear BoxOperating Voltage: 4.8 to 7.2V DCSpeed: 160 degrees with 0.17 sec (4.8V,no load)Stall Torque: 15 kg-cm at 6VConnector Wire: 300 mmMotor Weight: 55g approx.Package:1x MG996R Servo Motor1x accessory packTotal Weight: 65g approx...

Good Quality RS395 Type DC Motor usable down to 5VDC. With performance enhancing flux yoke to minimize magnetic leakage, keep the magnetic field inside of the motor where it is needed most.Nominal Voltage: 16.2VDCRated Power: 30WOperating Voltage: 5V-16.2VDCNo Load RPM: 11600rpm @ 12VDC, 5640rpm @ 6..

This motor is largely used in sliding doors, but can be easily repurposed for other functions. It has an integrated incremental encoder that you can use to monitor/control speed & position.Important: Intermittent use only. Not suitable for continous operation.Measured Parameters:Operating Voltage: 2..

Oriental Motor 100-115VAC motorMade in JapanNote: 30 mins duty. Not for continuous operationShort Specifications:Manufacturer: Oriental MotorFrame Size: 2.36inch (60mm)Overall length: 138mm (Tip of output shaft to motor base)Weight: 940gMotor:Output Power: 6WRunning Capacitor: 3.5uF 250VAC (Not incl..

Oriental Motor 100-115VAC Electromagnetic Brake motorMade in JapanNote: 30 mins duty. Not for continuous operationShort Specifications:Manufacturer: Oriental MotorFrame Size: 2.76inch (70mm)Overall length: 180mm (Tip of output shaft to motor base)Weight: 1640gMotor:Output Power: 15WRunning Capacitor..

Oriental Motor 100-115VAC motorMade in JapanNote: 30 mins duty. Not for continuous operationShort Specifications:Manufacturer: Oriental MotorFrame Size: 2.36inch (60mm)Overall length: 148mm (Tip of output shaft to motor base)Weight: 1100gMotor:Output Power: 6WRunning Capacitor: 3.5uF 250VAC (Not inc..

Oriental Motor 100-115VAC motorMade in JapanNote: 30 mins duty. Not for continuous operationShort Specifications:Manufacturer: Oriental MotorFrame Size: 2.36inch (60mm)Overall length: 148mm (Tip of output shaft to motor base)Weight: 1100gMotor:Output Power: 6WRunning Capacitor: 3.5uF 250VAC (Not inc..

Oriental Motor 100-115VAC motorMade in JapanNote: 30 mins duty. Not for continuous operationShort Specifications:Manufacturer: Oriental MotorFrame Size: 2.36inch (60mm)Overall length: 148mm (Tip of output shaft to motor base)Weight: 1100gMotor:Output Power: 6WRunning Capacitor: 3.5uF 250VAC (Not inc..